Plate zapping



The Prevention of all Cancers by Dr Hulda Clark

The Prevention of all Cancers by Dr Hulda Clark

by Dr Hulda Clark

‘For plate-zapping, stay connected for 20 minutes at any one tissue location, and move on to others after that.

Testing the Zapper

Trying the zapper on an illness to see “if it works” is not useful. Your symptoms may be due to a non-parasite. Or you may reinfect within hours of zapping. The best way to test your device is to find a few invaders that you currently have. (This is described in the Syncrometer® Science Laboratory Manual. This gives you an exact starting point. Then zap yourself. After the triple zapping, none of these invaders should be present. If they do survive, especially the larger ones like Fasciola flukes, they are undoubtedly saturated by an insulating substance such as PCBs, Freon or benzene. For this reason, plate-zapping is chosen.


By passing the zapper current through a capacitor plate in the same manner as the Syncrometer® current, a similar effect can be observed. The item placed on the plate directs or invites the current; in fact, nothing else will be zapped. My interpretation is that the capacitor plate on the resonance box has a “standing wave” relationship to an identical capacitance in your body (actually, a capacitance-inductance unit), making the resistance between them essentially zero.

For this reason the dimensions and composition of the capacitor plates are important. Nearly all the current will go to this location in your body. The standing wave relationship can be seen for the Syncrometer where the addition of two picofarads capacitance to the plate destroys resonance, but the further addition of two microhenrys inductance restores it again.’
(The Prevention of All Cancers pg.488 copyright)

Plate-Zapping Tips

Because you should use your feet to zap, you may wish to put the copper tubes on the floor. The tubes should be wrapped with only one layer of wet paper towel. To protect your floor, shove paper plates inside plastic bags underneath the tubes.
With plate-zapping, a 9 volt battery will wear out even quicker than for other arrangements. Of course, your body is benefiting from this greater energy input by converting it, in some way, for itself. You need to check the battery voltage after every zap at first. If the battery voltage ends up at 8.9 or lower, you will have to repeat the last zap. Start each zap at no less than 9.4 v. Expect to drain about .4 volts from the battery for each zap using this dual plate arrangement. Get rechargeable batteries, a battery charger, and a voltmeter all of which will save you money and delays.
For detailed instructions see the
Plate-Zapping Schedule on page 94.

(The Prevention of All Cancers pg.491 copyright)